MAB 1300

MAB 1300

Ø 130 mm Core Drilling & M42 Tapping

Technical Specs

Core drill short 30 mm
12-130 mm
Core dril long 55 mm
12-120 mm
Core drill extra-long 110 mm
20 - 120 mm
Thread cutting
<= M42
Countersinking
<= 80 mm
Reaming
<= 50 mm
Twist drilling
<= 45 mm
Friction clutch
Permanent internal lubrication
Speed range 1
30 - 80 min -1
Speed range 2
50 - 120 min-1
Speed range 3
130 - 350 min-1
Speed range 4
210 - 550 min-1
Morse taper
MT 4
Quick change drill chuck-system
----
Industrial arbor
----
Direct arbor
32 mm weldon
Weight
51 Kg
Magnet Size
120 x 360 x 65mm
Hub
310mm
Voltage
230 V or 110 V AC
Motor Output
2300 Watt
Swivel Base
----
Carbon brush wear control
CW/CCW rotation
Overheating protection
Magnet indicator
Full wave control electronics
Torque Control

The made in Germany worlds most powerful magnetic drilling and tapping machine - MAB 1300 This magnetic core drilling machine meets all the expectations that arise in arising in heavy engineering & fabrication shipbuilding production engineering etc Core drilling up to ø 130 mm (30 mm cutting depth) the whole spectrum of BDS core drills can be used with this machine: twist drilling reaming countersinking and thread cutting to M42 As a standard the MAB 1300 has a direct arbor with 32 mm Weldon shank (1 14") and a Morse Taper MT 4 If the steady is removed which can be done in just a few moments the machines stroke can be extended to a remarkable 310 mm The machine is fully equipped with all the safety measures of current magnetic core drilling technology: protection from machine overheating protection from tool damage alerts when the carbon brushes are worn and a warning when the magnet holding force is too low The MAB 1300 drilling system is delivered as standard in a stable carry case on wheels made out of impact resistant plastic It is thus very portable and easy to handle despite its weighty 51 kg The MAB 1300 even though being such a powerful machine it uses Single Phase power supply thus helping to reduce the power consumption

130mm

Diameter Drilling

M42

Tapping Capacity

2300Watt

Powerful Motor

51Kg

Weight

Full wave control electronics

Drilling with servo assist

Carbon Brush Wear Indicator

Reversible motor

Magnet indicator

Oil Bath Gearbox

Safe Switches

MT 4 Morse Taper

1 Carry case on wheels

1 Safety chain

1 Offset screwdriver SW 4, 6, 8

1 Drill drift MT 4

1 Ejector pin ZAK 075 + 090

1 Bushing ZAP 200, from 32 mm Weldon to 19 mm Weldon

1 Ejector pin ZAK 100 + 120

1 Operating manual

Product Videos