Insert the annular cutter in the machine arbor and tighten the screws correctly.
Move the magnetic base drilling machine towards the mark where the hole is to be drilled and with the help of the pilot pin locate the mark by touching the tip of the pilot pin over the mark.
After positioning the machine on the mark where the hole is to be made, switch on the magnet switch. Check if the magnet indicator glows GREEN.
Fill the coolant tank with BDS lubricant. Never use the machine without lubricant.
Set the correct RPM on the machine for the size of the cutter being used.
Turn ON the coolant tank knob of the magnetic base drilling machine.
You must use the internal lubrication when drilling with annular cutters. Also, use external lubrication when drilling above 50 mm thickness.
Switch ON the motor switch of the magnetic base drilling machine and start to drill with slow feed. Never crash the cutter onto the material.
Start to drill with firm steady feed rate. Too slow or too fast a feed rate will damage the cutter.
Check if the lubricant is coming out. Use a lot of lubricant for good results.
Putting too much pressure on the feed handle of the magnetic base drilling machine will not make drilling faster; instead, it will break the cutters.
Drill with less pressure and steady feed for best results and longer service life of annular cutters.
To prevent long chips forming you should use reverse feed when cutting deep holes.
To prevent accidents clean the work area with BDS PowerWORKER after drilling.
Perfect drilling with the above instructions with magnetic base drilling machine & annular cutters will result in perfectly finished holes, in less time and with more service life of both cutter and machine.
BDS Maschinen GmbH would like to offer you the best possible service. We store
information about your visit in so-called cookies. By using this website, you agree